Basic Dial NMS Implementation Guide
Table Of Contents
- Preface
- Overview of Basic SNMP Building Blocks
- Network Design for a DialNMSCase Study
- Dial MIBs and OIDs Used in the Case Study
- Task 1—Enabling SNMP in a Cisco IOS Device
- Task 2— Exploring SNMP Capabilities by Using UCD-SNMP
- Task 3—Using MRTG to Monitor and Graph Traffic Loads
- Task 4—Using Syslog, NTP, and Modem Call Records to Isolate and Troubleshoot Faults
- Task 5—Setting Up a Web Portal forthe DialNMS
- Task 6—Managing IP Addresses by Using DNS
- Task 7—Using HP OpenView to Create the SNMP Framework
- Task 8—Using CiscoWorks 2000 Resource Manager Essentials
Task 8Using CiscoWorks 2000 Resource Manager Essentials
About CiscoWorks 2000 RME
Basic Dial NMS Implementation Guide
Polling the Devices
To inspect the status and availability of the devices, follow these steps.
Step 1
From the
Tasks
menu, click on
Availability: Reachability Dashboard
.
Figure 35 The Status of the Devices
Step 2
Click a device to become familiar with the different management elements. Green arrows indicate
devices that are up. Red arrows indicate devices that are down.
Step 3
To turn on continuous availability monitoring and reporting, go to the
Tasks
menu. Click on
Availability
:
Availability Monitor
.
38629