Basic Dial NMS Implementation Guide
Table Of Contents
- Preface
- Overview of Basic SNMP Building Blocks
- Network Design for a DialNMSCase Study
- Dial MIBs and OIDs Used in the Case Study
- Task 1—Enabling SNMP in a Cisco IOS Device
- Task 2— Exploring SNMP Capabilities by Using UCD-SNMP
- Task 3—Using MRTG to Monitor and Graph Traffic Loads
- Task 4—Using Syslog, NTP, and Modem Call Records to Isolate and Troubleshoot Faults
- Task 5—Setting Up a Web Portal forthe DialNMS
- Task 6—Managing IP Addresses by Using DNS
- Task 7—Using HP OpenView to Create the SNMP Framework
- Task 8—Using CiscoWorks 2000 Resource Manager Essentials
Task 8Using CiscoWorks 2000 Resource Manager Essentials
About CiscoWorks 2000 RME
Basic Dial NMS Implementation Guide
Verifying that Device Polling is Turned On
To verify that polling is enabled or to alter any polling settings, follow these steps.
Step 1
From the
Admin
menu, click on
Availability
:
Change Polling Options
.
Step 2
In the Select Polled Views screen, select
All
Views
and
All Polled Views
.
Figure 34 Polling Setup
Step 3
Click
Next
.
Step 4
To accept the default settings, click
Finish
.