Router Installation and Configuration Guide

Contents

Cisco 7201 Installation and Configuration Guide

OL-11364-04

Configuring a Cisco 7201 Router 3-9

Performing a Basic Configuration Using AutoInstall 3-10

Performing a Basic Configuration Using the Setup Facility 3-10

Configuring Global Parameters 3-11

Configuring the Native Gigabit Ethernet Interfaces 3-15

Configuring Port Adapter Interfaces 3-17

Performing a Basic Configuration Using Global Configuration Mode 3-20

Checking the Running Configuration Settings 3-21

Saving the Running Configuration to NVRAM 3-21

Performing Other Configuration Tasks 3-22

Upgrading ROMmon on the Cisco 7201 3-22

Using the show rom-monitor Command and showmon Command 3-23

Using the upgrade rom-monitor Command 3-23

Changing Preferences to Change the ROMmon Image 3-24

Troubleshooting the Upgrade 3-24

ROMmon Upgrade Error Messages 3-24

Upgrading FPGA 3-25

Replacing or Recovering a Lost Password 3-26

Overview of the Password Recovery Procedure 3-26

Details of the Password Recovery Procedure 3-27

Viewing Your System Configuration 3-29

Performing Complex Configurations 3-30

CHAPTER

4 Removing and Installing an SFP Module 4-2

Removing an SFP Module 4-2

Installing an SFP Module 4-2

Removing and Installing the CompactFlash Disk 4-3

Removing and Installing a USB Flash Memory Module or

USB eToken Pro Key 4-4

Removing and Installing a Port Adapter or Service Adapter 4-5

Removing and Installing an AC Power Supply 4-7

Removing the AC Power Supply 4-7

Installing the AC Power Supply 4-9

Removing and Installing a DC Power Supply 4-10

Removing the DC Power Supply 4-10

Installing the DC Power Supply 4-11

Installing the DC Grounding Leads 4-12

Wiring the DC-Input Power Source 4-13