Bridge/Router Quick Start Guide

4
Cisco 1751 Voice-over-IP Quick Start Guide
78-11259-05
Installing WAN and Voice Interface Cards
Figure 2 Inserting a WIC or VIC in the Router
If you need more detailed installation instructions, refer to the Cisco WAN Interface Cards Hardware
Installation Guide.
Connecting the FXS, FXO, and E&M VICs to the Network
If you installed FXS, FXO, or E&M VICs, use the following cables, and refer to Figure 3 to connect
them to the network:
• Standard RJ-11 modular telephone cable to connect FXS VIC ports (color-coded gray) to a
telephone or fax machine.
• Standard RJ-11 modular telephone cable to connect FXO VIC ports (color-coded pink) to the PSTN,
or to a PBX that does not support E&M signaling, through a telephone wall outlet.
• Standard RJ-48S connector and cable to connect E&M VIC ports (color-coded brown) to a PBX line.
The cable wiring depends on the type of connection. For details, refer to the Cisco WAN Interface
Cards Hardware Installation Guide.
46565
Interface card
+5, +12, -12 VDC
C
O
N
S
O
LE
AU
X
Model Cisco 1750
10/100 ETHERNET
SEE MANUAL BEFORE INSTALLATION
V
IC
2
F
X
O
PVDM OK
MOD OK
SLOT 1
SLOT 2 OK
FDX
SLOT 0 OK
SLO
T 1 OK
100
LINK
THIS SLOT
ACCEPTS
ONLY VOICE
INTERFACE
CARDS
SLOT 2
SLOT 0
1
IN USE
0
IN USE
Guides
SEE MANUAL BEFORE INSTALLATION
V
IC
2
F
X
S
1
IN USE
0
IN USE