user manual

SpecificationItem
8525 BTUs/hrMax heat dissipation
DC wiring must meet your local codes and regulations, we recommend using a licensed local electrician to
install the DC wiring needed.
To determine the number of power supply units needed for the blade server, remember that each single slot
server is budgeted a max 550 W and each full width server is budgeted a max 1100 W. For a more detailed
estimate, contact Cisco Sales.
Supported AC Power Cords and Plugs
The AC power connectors on the blade server chassis PDU use an IEC 320 C20 socket. Each chassis power
supply has a separate power cord. The power cord that you use to connect the blade server power supply units
to an AC power source will have an IEC 320 C19 plug on one end and on the other end one that conforms to
the AC power outlet specifications for your country. See the following table to determine which cord to order
for your blade server chassis power supply units. When you determine which power cord you need to order,
you can verify that its plugs conform to the power outlets for your facility by clicking on its reference link.
The jumper power cords, for use in racks, are available as an optional alternative to the standard power cords.
The optional jumper power cords have an IEC C19 connector (such as a Cisco RP Series PDU) on the end
that plugs into the chassis’ PDU and an IEC C20 connector on the end that plugs into an IEC C19 outlet
receptacle. For more information, contact your Cisco Systems representative.
Only the regular power cords or jumper power cords provided with the chassis are supported.Note
Australia and New Zealand
Power Cord Part Number—CAB-AC-16A-AUS
Cord Set Rating—16A, 250 VAC
Figure 43: CAB-AC-16A-AUS Power Cord for the Cisco UCS 5108 Blade Server Chassis
Cordset rating: 16 A, 250 V
Length: 14 ft 0 in. (4.26 m)
140586
Connector: IEC 60320 C19
Plug: AU20S3
Cisco UCS 5108 Server Chassis Installation Guide
74 OL-20035-05
Technical Specifications
Supported AC Power Cords and Plugs