Network Router User Manual

4-14
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter 4 Configuring ESCON Signal Aggregation
Configuring Alarm Thresholds
Example
The following example shows how to create an alarm threshold list and configure that list for ESCON
multiplexing line card interfaces:
Switch# configure terminal
Switch(config)# threshold-list escon-counters
Switch(config-t-list)# threshold name crc degrade
Switch(config-threshold)# value rate 9
Switch(config-threshold)# exit
Switch(config-t-list)# threshold name crc failure
Switch(config-threshold)# value rate 7
Switch(config-threshold)# exit
Switch(config-t-list)# exit
Switch(config)# interface esconphy 3/0/0
Switch(config-if)# threshold-group escon-counters
Displaying the Alarm Threshold Configuration
To display the configuration of a threshold list and the threshold group for an esconphy interface, use
the following EXEC commands:
Examples
The following example shows how to display the configuration of a threshold group:
Switch# show threshold-list escon-counters
Threshold List Name: escon-counters
Notification throttle timer : 5 (in secs)
Threshold name : CRC Severity : Degrade
Value : 10e-9
APS Trigger : Not set
Threshold name : CRC Severity : Failure
Value : 10e-7
APS Trigger : Not set
8 2 2 103 0.07
9 0.2 0.2 10 0.007
Table 4-1 Threshold Values for Monitored Rates for ESCON Signals (Errors Per Second) (continued)
Rate ESCON CRC ESCON CVRD
10 Gigabit
Ethernet CVRD
10 Gigabit
Ethernet
CDL HEC
Command Purpose
show threshold-list [name] Displays the threshold group configuration.
show interfaces {esconphy slot/subcard/slot |
waveethernetphy slot/subcard |
tengigethernetphy slot/subcard}
Displays the interface configuration.