Network Router User Manual

4-9
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter 4 Configuring ESCON Signal Aggregation
Configuring 10-GE Uplink Card Interfaces
Displaying the 10-GE Uplink Card Interface Configuration
To display the configuration of 10-GE uplink card interfaces, use the following EXEC command:
Example
The following example shows how to display the configuration of an tengigethernetphy interface:
Switch# show interfaces tengigethernetphy 3/0
TenGigEthernetPhy3/0 is up, line protocol is up
Signal quality :Good
laser shut down :Off
Osc physical port :No
Loopback not set
Wavelength used for inband management:No
Configured threshold Group:None
CDL HEC error count:0
Number of times SF threshold exceeded:0
Number of times SD threshold exceeded:0
CRC error count:0
Number of times SF threshold exceeded:0
Number of times SD threshold exceeded:0
Code violation and running disparity error count( 64b66b cvrd):0
Number of times SF threshold exceeded:0
Number of times SD threshold exceeded:0
Defect Indication Status :up
Configured Node Behavior :None
Current Node Behavior :Path Terminating
Defect Indication Receive : None
Defect Indication Transmit : None
Total Tx Frames Sent to N/W: 48297
Tx Gen CDL Idle Frame: 2173636535
Rx Frames rcvd from N/W: 0
Rx CRC Errors: 0
Rx HEC Errors: 0
Rx XGMII Errors: 0
Rx IPG drpd pkts: 0
Rx Idle Packets : 1836560218
Rx Oversize Frames : 0
Rx Undersize Frames : 0
Rx SII mismatch drpd data Frames : 0
Rx SII mismatch drpd idle Frames : 1842816773
Last clearing of "show interface" counters never
Hardware is data_enabled_port
Command Purpose
show interfaces {tengigethernetphy
slot/0[.subinterface] |
wavepatch slot/0/port}
Displays the interface configuration.