Network Router User Manual

4-8
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter 4 Configuring ESCON Signal Aggregation
Configuring 10-GE Uplink Card Interfaces
Configuring 10-GE Uplink Card Interfaces
To configure the 10-GE uplink card interface, perform the following tasks, beginning in global
configuration mode:
Caution Loopbacks on tengigethernetphy interfaces disrupt service. Use this feature with care.
Note For configuration information for the ethernetdcc interface, see the “Configuring IP on Ethernetdcc
Interfaces for the In-Band Message Channel” section on page 9-12.
Example
The following example shows how to configure 10-GE uplink card interfaces:
Switch(config)# interface tengigethernetphy 10/0
Switch(config-if)# cdl defect-indication force hop-endpoint
Command Purpose
Step 1
Switch(config)# interface
tengigethernetphy slot/0
Switch(config-if)#
Selects the interface to configure and enters interface
configuration mode.
Step 2
Switch(config-if)# [no] loopback Enables or disables internal loopback for testing and
defect isolation. (Optional)
Step 3
Switch(config-if)# [no] laser shutdown Turns the laser on and off. (Optional)
Step 4
Switch(config-if)# [no] cdl defect-indication
force hop-endpoint
Enables or disables hop endpoint for in-band message
channel defect indications (Optional).
Step 5
Switch(config-if)# [no] shutdown Enables or disables the interface.
Step 6
Switch(config-if)# exit
Switch(config)
Returns to global configuration mode.
Step 7
Switch(config)# interface
tengigethernetphy slot/0.subinterface
Switch(config-subif)#
Selects the subinterface to configure and enters
interface configuration mode.
Step 8
Switch(config-subif)# [no] shutdown Enables or disables the interface.
Step 9
Switch(config-subif)# exit
Switch(config)
Returns to global configuration mode.
Step 10
Switch(config)# interface wavepatch
slot/subcard/port
Switch(config-if)#
Selects the interface to configure and enters interface
configuration mode.
Step 11
Switch(config-if)# no shutdown Enables the interface.