Network Router User Manual

4-6
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter 4 Configuring ESCON Signal Aggregation
Configuring 10-Gbps ITU Trunk Card Interfaces
Caution Loopbacks on waveethernetphy interfaces disrupt service. Use this feature with care.
Note For configuration information for the ethernetdcc interface, see the “Configuring IP on Ethernetdcc
Interfaces for the In-Band Message Channel” section on page 9-12.
Example
The following example shows how to configure 10-Gbps ITU trunk card waveethernetphy interfaces:
Switch(config)# interface waveethernetphy 10/0
Switch(config-if)# cdl defect-indication force hop-endpoint
Displaying the 10-Gbps ITU Trunk Card Interface Configuration
To display the configuration of 10-Gbps ITU trunk card interfaces, use the following EXEC command:
Examples
The following example shows how to display the configuration of a waveethernetphy interface:
Switch# show interfaces waveethernetphy 10/0
WaveEthernetPhy10/0 is down, line protocol is down
Channel:30 Frequency:195.7 Thz Wavelength:1531.90 nm
Active Wavepatch :Wavepatch10/0/1
Splitter Protected :No
Signal quality :Loss of lock
Receive power level :-35.0 dBm
Laser Bias Current :91 mA
Laser Temperature :31.0 degree C
Laser shut down :No
Osc physical port :No
Wavelength used for inband management:No
Loopback not set
Configured threshold Group:None
CDL HEC error count:0
Number of times SF threshold exceeded:0
Number of times SD threshold exceeded:0
CRC error count:0
Number of times SF threshold exceeded:0
Number of times SD threshold exceeded:0
Code violation and running disparity error count( 64b66b cvrd):0
Number of times SF threshold exceeded:0
Number of times SD threshold exceeded:0
Defect Indication Status :up
Configured Node Behavior :None
Current Node Behavior :Path Terminating
Defect Indication Receive : None
Defect Indication Transmit :BDI-H
Command Purpose
show interfaces {waveethernetphy
slot/0[.subinterface] | wavepatch slot/0/port}
Displays the interface configuration.