Network Router User Manual

4-5
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter 4 Configuring ESCON Signal Aggregation
Configuring 10-Gbps ITU Trunk Card Interfaces
Configuring 10-Gbps ITU Trunk Card Interfaces
To configure the 10-Gbps ITU trunk card interface, perform the following tasks, beginning in global
configuration mode:
Command Purpose
Step 1
Switch(config)# interface waveethernetphy
slot/0
Switch(config-if)#
Selects the interface to configure and enters interface
configuration mode.
Step 2
Switch(config-if)# [no] loopback Enables or disables internal loopback for testing and
defect isolation. (Optional)
Step 3
Switch(config-if)# [no] laser shutdown Turns the laser on and off. (Optional)
Note The laser must warm up for 2 minutes before
carrying traffic.
Step 4
Switch(config-if)# [no] cdl defect-indication
force hop-endpoint
Enables or disables hop endpoint for in-band message
channel defect indications (Optional).
Step 5
Switch(config-if)# no shutdown Enables the interface.
Step 6
Switch(config-if)# exit
Switch(config)
Returns to global configuration mode.
Step 7
Switch(config)# interface waveethernetphy
slot/0.subinterface
Switch(config-subif)#
Selects the subinterface to configure and enters
interface configuration mode.
Step 8
Switch(config-subif)# no shutdown Enables the interface.
Step 9
Switch(config-subif)# exit
Switch(config)
Returns to global configuration mode.
Step 10
Switch(config)# interface wavepatch
slot/0/0
Switch(config-if)#
Selects the interface to configure and enters interface
configuration mode.
Step 11
Switch(config-if)# optical threshold power
receive {low | high} {alarm | warning} value
[severity {critical | major | minor | not
alarmed | not reported}]
Specifies the optical power receive threshold value in
units of 0.1 dBm. The default values are as follows:
Low alarm: –22 dBm
Low warning: –20 dBm
High warning: –8 dBm
High alarm: –6 dBm
Alarm severity: major
Warning severity: not alarmed
Step 12
Switch(config-if)# [no] shutdown Enables or disables the interface.
Repeat Step 10 and Step 12 on wavepatch slot/0/1 for
splitter 10-Gbps ITU trunk cards.