Network Router User Manual

4-4
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter 4 Configuring ESCON Signal Aggregation
Configuring ESCON Multiplexing Line Card Interfaces
Example
The following example shows how to display the configuration of an esconphy interface:
Switch# show interfaces esconphy 7/0/0
EsconPhy7/0/0 is down, line protocol is down
Signal quality:Loss of light
Client Laser Status:Down due to Request from Remote
Forward laser control:On
Flow-identifier:40
Configured threshold Group:escon
Threshold monitored for:8b10b cvrd
SF set value:10e-3 (20000 in 1 secs)
Threshold monitored for:CRC
SF set value:10e-3 (19999 in 1 secs)
Received Frames:0
Transmit Frames:0
Code violation and running disparity error count(cvrd):0
Number of times SF threshold exceeded:0
Number of times SD threshold exceeded:0
CRC error count:0
Number of times SF threshold exceeded:0
Number of times SD threshold exceeded:0
Egress Packet Sequence error count:0
Egress Packet Indicated error count:0
5 minute input rate 0 bits/sec, 0 frames/sec
5 minute output rate 0 bits/sec, 0 frames/sec
Hardware is escon_phy_port
The following example shows how to display the configuration of a portgroup interface:
Switch# show interfaces portgroup 10/0/0
devt_ham_03/11#sh in portgroup 10/0/0
Portgroup10/0/0 is up, line protocol is up
Transmit Packets: 883067943
Received Packets: 887268737
Code violation and running disparity error count(cvrd): 247499080
Number of times SF threshold exceeded: 0
Number of times SD threshold exceeded: 0
CRC error count: 3
Number of times SF threshold exceeded: 0
Number of times SD threshold exceeded: 0
CDL HEC error count: 0
Number of times SF threshold exceeded: 0
Number of times SD threshold exceeded: 0
SII Mismatch error count: 0
ESCON Protocol Mismatch error count: 0
Hardware is portgroup