Network Router User Manual

A-225
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)E2
Appendix A Command Reference
Threshold Commands
value
To configure the values of failure and degrade alarm threshold rates, use the value command. To remove
an threshold rate, use the no form of the command.
value rate value
no value
Syntax Description
Defaults None
Command Modes Threshold configuration
Command History
Usage Guidelines First use the threshold-list command to enter threshold-list configuration mode and create a threshold
list. Then use the threshold command to specify a threshold to modify and enter threshold configuration
mode.
The degrade rate value for a threshold must always be less than the failure rate value. For example, if the
failure rate for a threshold is 7, or 10
-7
, then the degrade value must be 8 or 9.
Table A-47 lists the errors per second for the threshold rates for each of the protocol encapsulations.
rate value Enters the threshold value as 10
-x
, where value is x in 10
-x
. The range is
3to9.
Release Modification
12.1(10)EV2 This command was introduced.
Table A-47 Thresholds for Monitored Protocols on Transponder Line Cards (Errors Per Second)
Rate
SONET OC-3 or
SDH STM-1
SONET OC-12 or
SDH STM-4
SONET OC-48 or
SDH STM-16
Gigabit
Ethernet ESCON FICON
Fibre
Channel
1
1. Only 1 Gbps rate is supported.
ISC
2
2. Compatibility mode only.
3 31,753 32,000 32,000 1,244,390 199,102 1,057,731 1,057,731 1,057,731
4 12,318 27,421 31,987 124,944 19,991 106,202 106,202 106,202
5 1518 56,54 17,296 12,499 2000 10,625 10,625 10,625
6 155 616 2394 1250 200 1062 1062 1062
7 15.5 62 248 125 20 106 106 106
8 1.55 6.2 24.8 12.5 2 10.6 10.6 10.6
9 0.155 0.62 2.48 1.25 0.2 1.06 1.06 1.06