Network Router User Manual

A-223
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)E2
Appendix A Command Reference
Threshold Commands
threshold-list
To create a list of thresholds, or modify an existing threshold list, use the threshold-list command.
To delete the threshold list, use the no form of this command.
threshold-list name
no threshold-list name
Syntax Description
Defaults None
Command Modes Global configuration
Command History
Usage Guidelines Use this command to create a list, or modify an existing list, of signal degrade and signal failure alarm
thresholds for monitored error counters. After entering the command, the CLI enters threshold
configuration mode where you can specify the threshold list attributes or threshold counters to add or
modify.
Before deleting a threshold list, remove it from all the interfaces that use it.
Examples The following example shows how to create a threshold list called temp.
Switch# configure terminal
Switch(config)# threshold-list temp
Switch(config-t-list)#
Related Commands
name Specifies the name of the threshold list to be created and associated with a
specified interface.
Release Modification
12.1(10)EV2 This command was introduced.
Command Description
aps trigger Enables APS switchover when the alarm threshold is crossed.
description Specifies a threshold description for the SNMP MIB.
notification-throttle timer Modifies the alarm threshold notification throttle timer.
show threshold-list Displays the contents of a threshold list.
snmp-server enable traps
threshold min-severity
Enables SNMP trap notifications for alarm threshold activity.
threshold Creates failure and degrade thresholds for different error counters that
are monitored on the interface.