Network Router User Manual

2-8
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter 2 Before You Begin
Interface Naming Conventions
Figure 2-4 10-GE Uplink Card Interfaces
Ethernetdcc Interfaces
The in-band message channel OAM messages for inband management are sent and received by the CPU
switch module through the ethernetdcc interfaces. The ethernetdcc interface connects to the switch
fabrics on the backplane side and the waveethernetphy interface on the front panel side.
The naming convention for ethernetdcc interfaces is as follows:
ethernetdcc slot/subcard/port
Each 10-GE uplink card has one ethernetdcc interface.
Tengigethernetphy Interfaces
The tengigethernetphy interfaces correspond to the laser on the 10-GE uplink cards. The
tengigethernetphy interface connects to the tengigethernetphy subinterface on the backplane side of
the 10-GE uplink card and to the wavepatch interface on the front panel side. This is an uncolored
interface that carries 10 Gigabit Ethernet. This interface does not terminate layer 2 or layer 3 protocol
operations.
The naming convention for the tengigethernetphy interfaces is as follows:
tengigethernetphy slot/subcard/port
Each 10-GE uplink card has one tengigethernetphy interface.
Tengigethernetphy Subinterfaces
The tengigethernetphy interfaces are the backplane interfaces on the10-GE uplink cards. The
tengigethernetphy interface connects to the switch fabric.
Front panel
wavepatch 4/0/0
tengigethernetphy 4/0
tengigethernetphy 4/0.0
tengigethernetphy 4/0.1
tengigethernetphy 4/0.2
tengigethernetphy 4/0.3
Quad
Ser/Des
Backplane
ethernetdcc 4/0/0
79179