Network Router User Manual

A-67
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)E2
Appendix A Command Reference
Interface Configuration Commands
cdl flow identifier
To configure the in-band message channel flow identifier on an esconphy interface, use the cdl flow
identifier command.
To remove the flow identifier, use the no form of this command.
cdl flow identifier number
no cdl flow identifier
Syntax Description
Defaults None
Command Modes Interface configuration
Command History
Usage Guidelines Configure the same in-band message channel flow identifier on both interfaces supporting the signal.
Examples The following example shows how to configure the flow identified on an interface.
Switch# configure terminal
Switch(config)# interface esconphy 10/0/0
Switch(config-if)# cdl flow identifier 100
Related Commands
number Specifies the flow identifier for the signal. The range is 0 to 254.
Release Modification
12.1(10)EV2 This command was introduced.
Command Description
show interfaces Displays interface information.