Network Router User Manual

10-27
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter 10 Managing Your Cisco ONS 15530 System
Updating Functional Images
Address or name of remote host []? 10.0.0.1
Source filename []? fi-ons15530-escon.A.2-36.exo
Destination filename [fi-ons15530-escon.A.2-36.exo]? y
Loading tftpboot/ fi-ons15530-escon.A.2-36.exo from 10.0.0.1 (via Ethernet3/0):
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
[OK - 5779602/17912748 bytes]
5779602 bytes copied
Copying a Line Card Functional Image from an FTP Server to Flash Memory
To download a line card functional image from an FTP server, perform the following steps:
Command Purpose
Step 1
Switch# configure terminal
Switch(config)#
(Optional) Enters configuration mode from the
terminal. This step is required only if you override
the default remote username (see Step 2 and
Step 3). Otherwise, continue to Step 5.
Step 2
Switch(config)# ip ftp username username (Optional) Changes the default remote username.
Step 3
Switch(config)# ip ftp password password (Optional) Changes the default password.
Step 4
Switch(config)# end
Switch#
(Optional) Exits configuration mode. This step is
required only if you override the default remote
username (see Step 2 and Step 3).
Step 5
Switch# show {bootflash: | disk0:} Verifies that space is available in Flash memory. If
space is available, continue to Step 8.
Step 6
Switch# delete {bootflash: | disk0:}filename (Optional) Deletes a file from Flash memory.
Step 7
Switch# squeeze bootflash: (Optional) Recovers the space in onboard Flash
memory.
Step 8
Switch# copy
ftp:[[[//[username[:password]@]location]/
directory]/filename] {bootflash: |
disk0:}[filename]
Copies the image from the FTP server to the Flash
memory device.
Reply to any CLI prompts for additional
information or confirmation. The prompting
depends on how much information you provide in
the copy command.
Note Wait until after the download finishes
before attempting any commands on the
switch. Confirm that the image download
is done in binary mode and check file sizes
before and after download.