Network Router User Manual

10-22
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter 10 Managing Your Cisco ONS 15530 System
Updating Functional Images
Note For Cisco ONS 15530 systems with only one CPU switch module, you must either power cycle the shelf
or remove and reinsert the CPU switch module for the functional image upgrade to take effect.
Step 4
Switch# copy tftp:[[[//location]/directory]/filename]
{bootflash: | disk0:}[filename]
Copies the image from the TFTP server to the
Flash memory device.
Reply to any CLI prompts for additional
information or confirmation. The prompting
depends on how much information you provide
in the copy command.
Note Wait until after the download finishes
before attempting any commands on the
switch. Confirm that the image
download is done in binary mode and
check file sizes before and after
download.
Step 5
Switch# show {sby-bootflash: | sby-disk0:} Verifies that space is available in Flash memory
on the standby CPU switch module. If space is
available, continue to Step 8.
Step 6
Switch# delete {sby-bootflash: |
sby-disk0:}filename
(Optional) Deletes a file from Flash memory.
Step 7
Switch# squeeze sby-bootflash: (Optional) Recovers the space in onboard Flash
memory.
Step 8
Switch# copy tftp:[[[//location]/directory]/filename]
{sby-bootflash: | sby-disk0:}[filename]
Copies the image from the TFTP server to the
Flash memory device.
Reply to any CLI prompts for additional
information or confirmation. The prompting
depends on how much information you provide
in the copy command.
Note Wait until after the download finishes
before attempting any commands on the
switch. Confirm that the image
download is done in binary mode and
check file sizes before and after
download.
Step 9
Switch# reprogram {sby-bootflash: |
sby-disk0:}filename {slot | sby-rommon}
Updates the CPU switch module functional
image on the CPU switch module and returns
the CPU switch module to ROMMON mode.
Step 10
rommon 1 > boot [{bootflash: | disk0:}filename] (Optional) Boots the IOS system image on the
standby CPU switch module if it does not boot
automatically.
Step 11
Switch# redundancy switch-activity [force] Switches over control to the standby CPU
switch module.
Repeat Step 9 through Step 10 on the new
standby CPU switch module.
Command Purpose