Network Router User Manual

9-16
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter 9 Monitoring Your Network Topology
Configuring SNMP
Alarm Threshold MIB
The interface alarm threshold MIB (CISCO-IF-THRESHOLD-MIB) assists SNMP monitoring of the
interface alarm threshold activity. To enable the SNMP trap notifications for alarm threshold activity,
use the following global configuration command:
For information about other commands that enable SNMP trap notifications, refer to the
Cisco IOS Configuration Fundamentals Command Reference publication.
Example
The following example shows how to enable SNMP trap notifications for alarm thresholds and set the
minimum notification severity to signal degrade.
Switch# configure terminal
Switch(config)# snmp-server enable traps threshold min-severity degrade
APS MIB
The APS MIB (CISCO-APS-MIB) assists SNMP monitoring of SONET APS activity. To enable the
SNMP trap notifications for APS activity between associated interfaces, use the following global
configuration command:
For information about other commands that enable SNMP trap notifications, refer to the
Cisco IOS Configuration Fundamentals Command Reference publication.
Example
The following example shows how to enable SNMP trap notifications for APS.
Switch# configure terminal
Switch(config)# snmp-server enable traps aps
CDL MIB
The CDL MIB (CISCO-CDL-MIB) assists SNMP monitoring of the in-band message channel activity.
To enable the SNMP trap notifications for the in-band channel, use the following global configuration
command:
Command Purpose
snmp-server enable traps threshold
min-severity {degrade | failure}
Enables SNMP trap notifications for alarm threshold activity.
Command Purpose
snmp-server enable traps aps Enables SNMP trap notifications for APS activity.
Command Purpose
snmp-server enable traps cdl {all |
terminating-interfaces} [soak-interval seconds]
Enables SNMP trap notifications for the in-band
message channel activity.