Network Router User Manual

9-13
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter 9 Monitoring Your Network Topology
Configuring IP on Ethernetdcc Interfaces for the In-Band Message Channel
Note For detailed information about configuring routing protocols, refer to the Cisco IOS IP and IP
Routing Configuration Guide.
Example
The following example shows how to configure IP on the OSC on a three node system. Node 1 connects
to the NMS (network management system).
Node1# configure terminal
Node1(config)# interface loopback 1
Node1(config-if)# ip address 10.1.1.1 255.255.255.0
Node1(config-if)# exit
Node1(config)# interface fastethernet 0
Node1(config-if)# ip address 20.1.1.1 255.255.255.0
Step 4
Switch(config)# interface fastethernet 0
Switch(config-if)#
Selects the NME interface to configuration and
enters interface configuration mode.
Step 5
Switch(config-if)# ip address ip-address
subnet-mask
Configures IP address and subnet for the interface.
Step 6
Switch(config-if)# exit
Switch(config)#
Exits interface configuration mode and returns to
global configuration mode.
Step 7
Switch(config)# interface ethernetdcc slot/0/0
Switch(config-if)#
Selects the ethernetdcc interface.
Step 8
Switch(config-if)# ip unnumbered loopback 1 Configures an unnumbered interface referencing
the loopback interface.
Step 9
Switch(config-if)# exit
Switch(config)#
Exits interface configuration mode and returns to
global configuration mode.
Step 10
Switch(config)# ip route prefix prefix-mask
interface
or
Switch(config)# router ospf process-id
Switch(config-router)# network
network-address wildcard-mask area area-id
or
Switch(config)# router eigrp as-number
Switch(config-router)# network
network-number [network-mask]
or
Switch(config)# router bgp as-number
Switch(config-router)# network
network-number [mask network-mask]
Switch(config-router)# neighbor {ip-address |
peer-group-name} remote-as number
Configures IP static routes for some or all
destinations.
or
Configures OSPF as the routing protocol.
or
Configures EIGRP as the routing protocol.
or
Configures BGP as the routing protocol.
Command Purpose