Network Router User Manual

8-4
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter 8 Configuring Multiple Shelf Nodes
Configuring Multiple Shelf Nodes
For more information on configuring y-cable line card protection, refer to the “Configuring Y-Cable
Based Line Card Protection” section on page 7-10.
Examples
For these examples, assume the following:
• Channels 17–20 terminate on the second shelf of the multiple shelf node.
• The second shelf of the multiple shelf node has no OSC support.
• The management IP address of the second shelf of the multiple shelf node is 10.1.2.3.
• The management IP address of the single shelf node is 10.3.2.1.
The following example shows how to configure channels 17–20 on the single shelf node:
Switch(config)# redundancy
Switch(config-red)# associate group Channel17
Switch(config-red-aps)# aps working transparent 1/0/0
Switch(config-red-aps)# aps protection transparent 2/0/0
Switch(config-red-aps)# aps y-cable
Switch(config-red-aps)# aps far-end group Channel17 ip-address 10.1.2.3
Switch(config-red-aps)# aps enable
Switch(config-red-aps)# exit
Switch(config-red)# associate group Channel18
Switch(config-red-aps)# aps working transparent 3/0/0
Switch(config-red-aps)# aps protection transparent 4/0/0
Switch(config-red-aps)# aps y-cable
Switch(config-red-aps)# aps far-end group Channel18 ip-address 10.1.2.3
Switch(config-red-aps)# aps enable
Switch(config-red-aps)# exit
Switch(config-red)# associate group Channel19
Switch(config-red-aps)# aps working transparent 7/0/0
Switch(config-red-aps)# aps protection transparent 8/0/0
Switch(config-red-aps)# aps y-cable
Switch(config-red-aps)# aps far-end group Channel19 ip-address 10.1.2.3
Switch(config-red-aps)# aps enable
Switch(config-red-aps)# exit
Switch(config-red)# associate group Channel20
Switch(config-red-aps)# aps working transparent 9/0/0
Switch(config-red-aps)# aps protection transparent 10/0/0
Switch(config-red-aps)# aps y-cable
Switch(config-red-aps)# aps far-end group Channel20 ip-address 10.1.2.3
Switch(config-red-aps)# aps enable
Switch(config-red-aps)# end
Switch# copy system:running-config nvram:startup-config
Step 4
Switch(config-red-aps)# aps working
wavepatch slot/subcard/port
Configures the working path interface.
Step 5
Switch(config-red-aps)# aps protection
wavepatch slot/subcard/port
Configures the protection path interface.
Step 6
Switch1(config-red-aps)# aps y-cable Enables y-cable protection. The default state is no
y-cable protection (disabled).
Step 7
Switch1(config-red-aps)# aps
message-channel ip far-end group
group-name ip-address address
Configures the APS group name and IP address on the
remote node that supports the channel.
Step 8
Switch1(config-red-aps)# aps enable Enables APS activity between the interfaces.
Command Purpose