Network Router User Manual

7-16
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter 7 Configuring APS
Configuring APS Group Attributes
To configure revertive switching, use the following commands, beginning in global configuration mode:
Displaying the Revertive Switching Configuration
To display the revertive switching configuration, use the following EXEC command:
Command Purpose
Step 1
Switch(config)# redundancy
Switch(config-red)#
Enters redundancy configuration mode.
Step 2
Switch(config-red)# associate group name
Switch(config-red-aps)#
Selects the interfaces to associate and enters APS
configuration mode.
Note The group name is case sensitive.
Step 3
Switch(config-red-aps)# aps disable Disables APS activity between the interfaces.
Step 4
Switch(config-red-aps)# aps timer
wait-to-restore seconds
Modifies the interval for the wait-to-restore timer. If
revertive protection is configured and a switchover
has occurred, the system will wait this amount of time
before switching back to the functioning working
path. The default value is 300 seconds. (Optional)
Step 5
Switch(config-red-aps)# aps revertive Enables revertive switchover behavior. The default
behavior is nonrevertive.
Step 6
Switch(config-red-aps)# aps enable Enables APS activity between the interfaces.
Command Purpose
show aps [detail | group name |
interface {transparent slot/subcard/0 |
wavepatch slot/subcard/port |
waveethernetphy slot/subcard/0 |
gigethernetphy slot/subcard/0}]
Displays the APS configuration for interfaces and
groups.
Note Group names are case sensitive.