Network Router User Manual

5-10
Cisco ONS 15530 Configuration Guide and Command Reference
78-14227-01, Cisco IOS Release 12.1(10)EV2
Chapter 5 Configuring Transponder Line Card Interfaces
Configuring Alarm Thresholds
Configuring Alarm Thresholds
To configure alarm thresholds on transparent interfaces, perform the following steps, beginning in global
configuration mode:
Note If a threshold type does not apply to the encapsulation type for the interface, that threshold type is
ignored.
Command Purpose
Step 1
Switch(config)# threshold-list name
Switch(config-t-list)#
Creates or selects the threshold list to configure and
enters threshold list configuration mode.
Step 2
Switch(config-t-list)# notification-throttle
timer seconds
Configures the SNMP notification timer. The default
value is 5 seconds. (Optional)
Step 3
Switch(config-t-list)# threshold name
{8b10b cvrd | cdl hec | sonet-sdh section cv}
{failure | degrade} [index value]
Switch(config-threshold)#
Specifies a threshold type to modify and enters
threshold configuration mode.
Step 4
Switch(config-threshold)# value rate value Specifies the threshold rate value. This value is the
negative power of 10 (10
-n
).
Step 5
Switch(config-threshold)# description text Specifies a description of the threshold. The default
value is the null string. (Optional)
Step 6
Switch(config-threshold)# aps trigger Enables APS switchover when this threshold is
crossed. (Optional)
Note This command only triggers switchovers for
y-cable protection, not for splitter protection.
Step 7
Switch(config-threshold)# exit
Switch(config-t-list)#
Returns to threshold list configuration mode.
Repeat Step 3 through Step 7 to configure more
thresholds in the threshold list.
Step 8
Switch(config-t-list)# exit
Switch(config)#
Returns to global configuration mode.
Step 9
Switch(config)# interface {transparent
slot/subcard/0 | wave slot/subcard}
Switch(config-if)#
Selects the transparent or wave interface to configure
and enters interface configuration mode.
Step 10
Switch(config-if)# threshold-group name Configures the threshold list on the interface.