- Cisco Nexus 7000 Series Manual

Send document comments to [e-mail]
3-15
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-18634-01
Chapter 3 Installing a Cisco Nexus 7018 Chassis
Installing the Cable Management Assemblies
Figure 3-8 Attaching the Lower Left Cable Management Assembly to the Left Rack-Mount
Bracket
Step 2 Attach an upper cable management assembly (800-31342-01) onto the two hooks that protrude from the
upper half of the left rack-mount bracket that is attached to the Cisco Nexus 7018 device chassis, and
loosely fasten the assembly to the chassis with four flat-head M4x10 screws as shown in
Figure 3-9.
1 Lower cable management assembly 2 Left rack-mount bracket
3 Position the assembly so that the two lower
hooks on the rack-mount bracket fit inside the
two holes on the assembly, and then slide the
assembly down so that it is held by the hooks.
4 Loosely fasten the assembly to the
rack-mount bracket with four M4x10 screws.
Do not tighten these screws.
1
2
4
3
3
192181