Routing Switch Reference Guide

3-23
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter 3 Equipment and Resource Provisioning
cnfapsln
cnfapsln
Configure APS Line
Configures the APS parameters for a line (working line). Use the cnfapsln command after creating the
line using the addapsln command.
See the description for the addapsln command for a detailed explanation of Automatic Protection
Switching (APS).
Cards on Which This Command Runs
AXSM
Syntax
cnfapsln
-w <working line>
[-sf SignalFaultBER ]
[-sd SignalDegradeBER]
[-wtr Wait To Restore]
[-dr direction]
[-rv revertive]
Syntax Description
workingLine Slot number, bay number, and line number of the active line to configure, in
the format:
slot.bay.line
Example: -w 1.1.1
SignalFaultBER A number between 3 and 5 indicating the Signal Fault Bit Error Rate (BER),
in powers of ten:
• 3 = 10
-3
• 4 = 10
-4
• 5 = 10
-5
Example: -sf 3
SignalDegradeBER A power if 10 in the range 5–9 that indicates the Signal Degrade Bit Error
Rate (BER):
• 5 = 10
-5
• 6 = 10
-6
• 7 = 10
-7
• 8 = 10
-8
• 9 = 10
-9
Example: -sd 5