Network Router User Manual

14 Cisco IOS for S/390 Release 2.0 Release Notes
Documentation
The REFRESH command is described in the “Cisco IOS for S/390 Operation” chapter.
Parameters for the SVCDUMP Command
Two parameters have been added to the SVCDUMP command, ASID and JOBname. These
parameters let the user request that other address spaces be dumped along with Cisco IOS for S/390.
The SVCDUMP command is described in the “Cisco IOS for S/390 Operation” chapter.
Protocol Layer Events (Subtypes 110 - 123) Descriptions
The SMF subtype 110-123 records, described on page 3-17, are written to record certain
protocol-related events, such as a bind or connect request.
The following table describes the relationship of each of these subtypes:
MU1IUCV USERMOD Correction
The zap example for EZASOK03 configuration overrides and defaults on page 4-14 and the
USERMOD on page 4-15 are incorrect. Use USERMOD MU1IUCV in the SAMP data set instead.
ASID(asid_list) A list of address space IDs. Cisco IOS for S/390 will include these
address spaces in the dump. This parameter can be combined with the
JOBname parameter for a total of five address spaces.
The address space IDs may be listed in decimal or in hexadecimal
notation, as x’999’.
JOBname(jobname_list) A list of one-to-eight character jobnames. Cisco IOS for S/390 will
include these address spaces in the dump. This parameter can be
combined with the ASID parameter for a total of five address spaces.
Note: If there is more than one job active in the system with the same
jobname Cisco IOS for S/390 will dump the first one found in the
Address Space Vector Table.
Subtype Description
110 Endpoint create
111 TCP connect request
112 TCP accept request
113 TCP connection close
114 TCP bind
115 TCP unbind
116 TCP listen
117 UDP bind
118 UDP connect
119 UDP close
120 RAW open
121 RAW close
122 Endpoint destroy
123 Inbound connection failures