user manual

DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Removes any existing SPAN configuration for the session.
no monitor session {session_number |
all | local | remote}
Step 2
•
For session_number, the range is 1 to 66.
Example:
Switch(config)# no monitor session
all
• all—Removes all SPAN sessions.
• local—Removes all local sessions.
• remote—Removes all remote SPAN sessions.
Specifies the SPAN session and the source port (monitored port).
monitor session session_number source
{interface interface-id | vlan vlan-id}
[, | -] [both | rx | tx]
Step 3
•
For session_number, the range is 1 to 66.
Example:
Switch(config)# monitor session 1
•
For interface-id, specify the source port or the source VLAN to monitor.
•
For source interface-id, specify the source port to monitor. Only physical
interfaces are valid.
source interface
gigabitethernet1/0/1
•
For vlan-id, specify the source VLAN to monitor. The range is 1 to 4094
(excluding the RSPAN VLAN).
A single session can include multiple sources (ports or VLANs)
defined in a series of commands, but you cannot combine source
ports and source VLANs in one session.
Note
•
(Optional) [, | -] Specifies a series or range of interfaces. Enter a space before
and after the comma; enter a space before and after the hyphen.
•
(Optional) Specifies the direction of traffic to monitor. If you do not specify
a traffic direction, the SPAN monitors both sent and received traffic.
• both—Monitors both sent and received traffic. This is the default.
• rx—Monitors received traffic.
• tx—Monitors sent traffic.
You can use the monitor session session_number source command
multiple times to configure multiple source ports.
Note
Specifies the SPAN session and the destination port (monitoring port).
monitor session session_number
destination {interface interface-id [, |
-] [encapsulation replicate]}
Step 4
For local SPAN, you must use the same session number for the source
and destination interfaces.
Note
Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX
OL-29044-01 79
Configuring SPAN and RSPAN
Creating a Local SPAN Session