user manual

DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Limits the TFTP servers used for configuration file copies through SNMP
to the servers in the access list.
snmp-server tftp-server-list
access-list-number
Step 2
Example:
Switch(config)# snmp-server
tftp-server-list 44
For access-list-number, enter an IP standard access list numbered from 1
to 99 and 1300 to 1999.
Creates a standard access list, repeating the command as many times as
necessary.
access-list access-list-number {deny |
permit} source [source-wildcard]
Step 3
Example:
Switch(config)# access-list 44 permit
10.1.1.2
For access-list-number, enter the access list number specified in Step 2.
The deny keyword denies access if the conditions are matched. The permit
keyword permits access if the conditions are matched.
For source, enter the IP address of the TFTP servers that can access the
switch.
(Optional) For source-wildcard, enter the wildcard bits, in dotted decimal
notation, to be applied to the source. Place ones in the bit positions that
you want to ignore.
The access list is always terminated by an implicit deny statement for
everything.
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 4
Monitoring SNMP Status
To display SNMP input and output statistics, including the number of illegal community string entries, errors,
and requested variables, use the show snmp privileged EXEC command. You also can use the other privileged
EXEC commands listed in the table to display SNMP information.
Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX
62 OL-29044-01
Configuring Simple Network Management Protocol
Monitoring SNMP Status