user manual

DescriptionNotification Type Keyword

Generates SNMP port security traps. You can also set a maximum

trap rate per second. The range is from 0 to 1000; the default is 0,

which means that there is no rate limit.

When you configure a trap by using the notification type

port-security, configure the port security trap first, and

then configure the port security trap rate:

Note

snmp-server enable traps port-security

snmp-server enable traps port-security trap-rate rate

port-security

Generates a trap for the SNMP Response Time Reporter (RTR).rtr

Generates a trap for SNMP-type notifications for authentication,

cold start, warm start, link up or link down.

snmp

Generates a trap for SNMP storm-control. You can also set a

maximum trap rate per minute. The range is from 0 to 1000; the

default is 0 (no limit is imposed; a trap is sent at every occurrence).

storm-control

Generates SNMP STP Extended MIB traps.stpx

Generates SNMP syslog traps.syslog

Generates a trap for TCP connections. This trap is enabled by default.tty

Generates a trap for SNMP VLAN membership changes.vlan-membership

Generates SNMP VLAN created traps.vlancreate

Generates SNMP VLAN deleted traps.vlandelete

Generates a trap for VLAN Trunking Protocol (VTP) changes.vtp

Beginning in privileged EXEC mode, follow these steps to configure the switch to send traps or informs to a

host.

Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX

OL-29044-01 57

Configuring Simple Network Management Protocol

Configuring SNMP Notifications