user manual

PurposeCommand or Action
•
The engineid-string is a 24-character ID string with the name of the copy of
SNMP. You need not specify the entire 24-character engine ID if it has trailing
[udp-port port-number]
engineid-string}
zeros. Specify only the portion of the engine ID up to the point where only
Example:
Switch(config)# snmp-server
engineID local 1234
zeros remain in the value. The Step Example configures an engine ID of
123400000000000000000000.
•
If you select remote, specify the ip-address of the device that contains the
remote copy of SNMP and the optional User Datagram Protocol (UDP) port
on the remote device. The default is 162.
Configures a new SNMP group on the remote device.
snmp-server group group-name {v1 |
v2c | v3 {auth | noauth | priv}} [read
Step 3
For group-name, specify the name of the group.
readview] [write writeview] [notify
notifyview] [access access-list]
Specify one of the following security models:
Example:
Switch(config)# snmp-server group
public v2c access lmnop
•
v1 is the least secure of the possible security models.
•
v2c is the second least secure model. It allows transmission of informs and
integers twice the normal width.
•
v3, the most secure, requires you to select one of the following authentication
levels:
auth—Enables the Message Digest 5 (MD5) and the Secure Hash Algorithm
(SHA) packet authentication.
noauth—Enables the noAuthNoPriv security level. This is the default if no
keyword is specified.
priv—Enables Data Encryption Standard (DES) packet encryption (also called
privacy).
(Optional) Enter read readview with a string (not to exceed 64 characters) that is
the name of the view in which you can only view the contents of the agent.
(Optional) Enter write writeview with a string (not to exceed 64 characters) that is
the name of the view in which you enter data and configure the contents of the agent.
(Optional) Enter notify notifyview with a string (not to exceed 64 characters) that
is the name of the view in which you specify a notify, inform, or trap.
(Optional) Enter access access-list with a string (not to exceed 64 characters) that
is the name of the access list.
Adds a new user for an SNMP group.
snmp-server user username
group-name {remote host [ udp-port
Step 4
The username is the name of the user on the host that connects to the agent.
port]} {v1 [access access-list] | v2c
The group-name is the name of the group to which the user is associated.
[access access-list] | v3 [encrypted]
[access access-list] [auth {md5 | sha}
Enter remote to specify a remote SNMP entity to which the user belongs and the
hostname or IP address of that entity with the optional UDP port number. The default
is 162.
auth-password] } [priv {des | 3des | aes
{128 | 192 | 256}} priv-password]
Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX
54 OL-29044-01
Configuring Simple Network Management Protocol
Configuring SNMP Groups and Users