user manual

SUMMARY STEPS
1.
configure terminal
2.
cns template connect name
3.
cli config-text
4.
Repeat Steps 2 to 3 to configure another CNS connect template.
5.
exit
6.
cns connect name [retries number] [retry-interval seconds] [sleep seconds] [timeout seconds]
7.
discover {controller controller-type | dlci [subinterface subinterface-number] | interface [interface-type]
| line line-type}
8.
template name [... name]
9.
Repeat Steps 7 to 8 to specify more interface parameters and CNS connect templates in the CNS connect
profile.
10.
exit
11.
hostname name
12.
ip route network-number
13.
cns id interface num {dns-reverse | ipaddress | mac-address} [event] [image]
14.
cns id {hardware-serial | hostname | string string | udi} [event] [image]
15.
cns config initial {hostname | ip-address} [port-number] [event] [no-persist] [page page] [source
ip-address] [syntax-check]
16.
end
DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Enters CNS template connect configuration mode, and specifies the name
of the CNS connect template.
cns template connect name
Example:
Switch(config)# cns template connect
template-dhcp
Step 2
Enters a command line for the CNS connect template. Repeat this step for
each command line in the template.
cli config-text
Example:
Switch(config-tmpl-conn)# cli ip
address dhcp
Step 3
Repeat Steps 2 to 3 to configure another
CNS connect template.
Step 4
Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX
24 OL-29044-01
Configuring Cisco IOS Configuration Engine
Enabling an Initial Configuration for Cisco IOS CNS Agent