user manual

PurposeCommand or Action
Example:
Switch(config)# monitor session 2
destination remote vlan 5
•
For vlan-id, specify the destination RSPAN VLAN to monitor.
Enters the VLAN configuration mode. For vlan-id, specify the source
RSPAN VLAN to monitor.
vlan vlan-id
Example:
Switch(config)# vlan 10
Step 5
Specifies that the VLAN you specified in Step 5 is part of the RSPAN
VLAN.
remote-span
Example:
Switch(config-vlan)# remote-span
Step 6
Returns to global configuration mode.exit
Example:
Switch(config-vlan)# exit
Step 7
Specifies the RSPAN session, the types of packets to filter, and the ACLs
to use in an FRSPAN session.
monitor session session_number filter {ip
| ipv6 | mac} access-group
{access-list-number | name}
Step 8
• For session_number, specify the session number entered in Step 3.
Example:
Switch(config)# monitor session 2
filter ip access-group 7
•
For access-list-number, specify the ACL number that you want to
use to filter traffic.
•
For name, specify the ACL name that you want to use to filter traffic.
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 9
Monitoring SPAN and RSPAN Operations
The following table describes the command used to display SPAN and RSPAN operations configuration and
results to monitor operations:
Table 13: Monitoring SPAN and RSPAN Operations
Displays the current SPAN, RSPAN, FSPAN,
or FRSPAN configuration
show monitor
Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX
OL-29044-01 95
Configuring SPAN and RSPAN
Monitoring SPAN and RSPAN Operations