user manual

7
Release Notes for Cisco ONS 15600 Release 8.0
OL-10906-01
Caveats
CSCdy54737
The following PM parameters can not be retrieved through SNMP.
• Line:
– FC-L
• Path:
– FC-P
– PPJC-Pdet
– NPJC-Pdet
– PPJC-Pgen
– NPJC-Pgen
• Protection groups:
– PSC
– PSD
• Far End counts for line and path
• 1-Day PM counts
To retrieve these counts, use CTC. SNMP support for these parameters may be considered for a future
release.
Bridge and Roll
CSCdy14265
The manual bridge and roll feature allows you to perform the END command once the roll operation
transitions from a ROLL PENDING to ROLL condition, even if the roll to port has an invalid signal. To
avoid traffic impact, ensure that the roll-to line is alarm-free. If an alarm exists, you can choose to do
nothing and wait for the alarm to clear, to delete the roll, or to proceed in spite of the alarm. This issue
will not be resolved.
Alarms
CSCsd52527
The AS-MT and the AS-CMD alarms do not show up on the alarm profile in CTC, so you cannot change
the severity of these alarm using CTC. This issue will be resolved in a future release.