- Cisco Grid Module for CGR 1000 Series

23
Cisco Connected Grid Modules for CGR 1000 Series—WiMAX Installation and Configuration Guide
OL-26236-03
Troubleshooting and Diagnostics
Initial RNG Backoff Start : 0
Initial RNG Backoff End : 5
Periodic RNG Backoof Start : 0
Periodic RNG Backoff End : 3
Bandwidth Request Backoof Start : 0
Bandwidth Request Backoff End : 3
UL Permutation : 0
UL Subchannel-bitmap : 0xff 0xff 0xff 0xff 0xff 0xff 0xff 0xff
Initial-RNG code qty : 4
Periodic-RNG code qty : 4
BWR code qty : 4
DLC CONFIG:
bsEirp (dBm) : 4.0
maxRssInitRanging (dBm) : 0.0
PHY:
BSiD :0000.000.0000
Qos Classifiers : 6
Qos Connections : 6
show interfaces wimax interface_name statistics
The following is an example of the show interfaces wimax interface_name statistics command:
Router # show interfaces wimax 2/1 statistics
WiMAX Statistics (Cumulative Total/Last 5 Seconds):
RECEIVER TRANSMITTER
Host Rx K Bytes: 923438 / 24366 Host Tx K Bytes: 115 / 0
Unicasts Rx: 0 / 0 Unicasts Tx: 0 / 0
Unicasts to host: 0 / 0 Unicasts by host: 0 / 0
Broadcasts Rx: 29482 / 734 Broadcasts Tx: 0 / 0
TBD. Add stats provided by proximetry
show interface wimax interface_name scanning
The following is an example of the show interfaces wimax interface_name scanning command:
Router # show interface wimax 3/1 scanning
Scan results for interface: Wimax3/1
BSID: 00:02:AA:00:00:01
Frequency: 2310000
NAPID: 00:02:AA
RSSI: -82 dBm
CINR: 20 dB
Troubleshooting and Diagnostics
This section provides the necessary background information and resources available for troubleshooting
the 2G/3G Connected Grid module.
• WiMAX Debug Commands, page 24
• Checking Signal Strength, page 24
• Retrieving the Electronic Serial Number, page 24
• Converting Hexadecimal ESN to Decimal Notation, page 25