user manual

Related Topics
Configuring a Trunk Port, on page 67
Feature Interactions, on page 66
Example: Removing a VLAN
This example shows how to remove VLAN 2 from the allowed VLAN list on a port:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# switchport trunk allowed vlan remove 2
Switch(config-if)# end
Related Topics
Defining the Allowed VLANs on a Trunk
Where to Go Next
After configuring VLAN trunks, you can configure the following:
•
VTP
•
VLANs
•
Private VLANs
•
VLAN Membership Policy Server (VMPS)
•
Tunneling
•
Voice VLANs
Additional References
Related Documents
Document TitleRelated Topic
Catalyst 2960-XR Switch VLAN Management
Command Reference
For complete syntax and usage information for the
commands used in this chapter.
Standards and RFCs
TitleStandard/RFC
——
Catalyst 2960-XR Switch VLAN Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29440-01 81
Configuring VLAN Trunks
Example: Removing a VLAN