user manual

PurposeCommand or Action
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 10
Related Topics
IEEE 802.1Q Tunneling, on page 124
IEEE 802.1Q Tunneling and Incompatibilities, on page 122
Example: Configuring an IEEE 802.1Q Tunneling Port, on page 143
Configuring Layer 2 Protocol Tunneling
SUMMARY STEPS
1.
configure terminal
2.
interface interface-id
3.
Use one of the following:
•
switchport mode access
•
switchport mode dot1q-tunnel
4.
l2protocol-tunnel [cdp | lldp | point-to-point | stp | vtp]
5.
l2protocol-tunnel shutdown-threshold [ packet_second_rate_value | cdp | lldp point-to-point | stp |
vtp]
6.
l2protocol-tunnel drop-threshold [ packet_second_rate_value | cdp | lldp | point-to-point | stp | vtp]
7.
exit
8.
errdisable recovery cause l2ptguard
9.
l2protocol-tunnel cos value
10.
end
11.
show l2protocol
12.
copy running-config startup-config
Catalyst 2960-XR Switch VLAN Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29440-01 135
Configuring IEEE 802.1Q and Layer 2 Protocol Tunneling
Configuring Layer 2 Protocol Tunneling