user manual

Negotiation of Trunking: Off
Access Mode VLAN: 1 (default)
Trunking Native Mode VLAN: 1 (default)
Administrative Native VLAN tagging: enabled
Voice VLAN: none
Administrative private-vlan host-association: 20 501
Administrative private-vlan mapping: none
Administrative private-vlan trunk native VLAN: none
Administrative private-vlan trunk Native VLAN tagging: enabled
Administrative private-vlan trunk encapsulation: dot1q
Administrative private-vlan trunk normal VLANs: none
Administrative private-vlan trunk private VLANs: none
Operational private-vlan:
20 501
<output truncated>
Related Topics
Configuring a Layer 2 Interface as a Private VLAN Host Port, on page 96
Private VLANs Ports, on page 88
Example: Configuring an Interface as a Private VLAN Promiscuous Port
This example shows how to configure an interface as a private VLAN promiscuous port and map it to a private
VLAN. The interface is a member of primary VLAN 20 and secondary VLANs 501 to 503 are mapped to it.
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# switchport mode private-vlan promiscous
Switch(config-if)# switchport private-vlan mapping 20 add 501-503
Switch(config-if)# end
Related Topics
Configuring a Layer 2 Interface as a Private VLAN Promiscuous Port, on page 98
Private VLANs Ports, on page 88
Example: Mapping Secondary VLANs to a Primary VLAN Interface
This example shows how to map the interfaces fo VLANs 501 and 502 to primary VLAN 10, which permits
routing of secondary VLAN ingress traffic from private VLANs 501 and 502:
Switch# configure terminal
Switch(config)# interface vlan 10
Switch(config-if)# private-vlan mapping 501-502
Switch(config-if)# end
Switch# show interfaces private-vlan mapping
Interface Secondary VLAN Type
--------- -------------- -----------------
vlan10 501 isolated
vlan10 502 community
Related Topics
Mapping Secondary VLANs to a Primary VLAN Layer 3 VLAN Interface, on page 99
Catalyst 2960-XR Switch VLAN Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29440-01 103
Configuring Private VLANs
Example: Configuring an Interface as a Private VLAN Promiscuous Port