- Cisco ONS 15454 Manual

Figures
xx
Cisco ONS 15454 Installation and Operations Guide
November 2001
Figure 9-4 A Single-card EtherSwitch configuration 9-5
Figure 9-5 A Multicard EtherSwitch point-to-point circuit 9-7
Figure 9-6 A Single-card Etherswitch point-to-point circuit 9-7
Figure 9-7 Provisioning an Ethernet circuit 9-8
Figure 9-8 Choosing a circuit source 9-8
Figure 9-9 A shared packet ring Ethernet circuit 9-10
Figure 9-10 Choosing a VLAN name and ID 9-11
Figure 9-11 Selecting VLANs 9-12
Figure 9-12 Adding a span 9-12
Figure 9-13 Viewing a span 9-13
Figure 9-14 A Hub and Spoke Ethernet circuit 9-14
Figure 9-15 Ethernet manual cross-connects 9-17
Figure 9-16 Creating an Ethernet circuit 9-17
Figure 9-17 Selecting VLANs 9-18
Figure 9-18 Creating an Ethernet circuit 9-19
Figure 9-19 Selecting VLANs 9-20
Figure 9-20 A Q-tag moving through a VLAN 9-23
Figure 9-21 The priority queuing process 9-24
Figure 9-22 Configuring VLAN membership for individual Ethernet ports 9-25
Figure 9-23 An STP blocked path 9-26
Figure 9-24 The spanning tree map on the circuit screen 9-28
Figure 9-25 MAC addresses recorded in the MAC table 9-30
Figure 9-26 Creating RMON thresholds 9-33
Figure 10-1 Viewing alarms in the CTC node view 10-2
Figure 10-2 Selecting the Affected Circuits option 10-4
Figure 10-3 Highlighted circuit appears 10-5
Figure 10-4 Viewing fault conditions retrieved under the Conditions tabs 10-6
Figure 10-5 Viewing all alarms reported for the current session 10-7
Figure 10-6 The LCD panel 10-8
Figure 10-7 Alarm profiles screen showing the default profiles of the listed alarms 10-9
Figure 10-8 Node view of a DS1 alarm profile 10-12
Figure 10-9 Card view of a DS1 alarm profile 10-12
Figure 10-10 The suppress alarms checkbox 10-14
Figure 11-1 A basic network managed by SNMP 11-2
Figure 11-2 An SNMP agent gathering data from an MIB and sending traps to the manager 11-2