Bridge/Router Installation and Configuration Guide

7-85
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
OL-11495-01
Chapter 7 Maintaining the Router
Removing and Replacing Cards from the Chassis
Step 2 Remove the card:
a. Pivot the ejector levers to unseat the card from the backplane connector.
b. Grasp the card by its metal card carrier and slide the card out of the slot
(
Figure 7-52).
– Place the card directly into an antistatic bag or other ESD-preventive
container.
Figure 7-52 Removing a Card from the Switch Fabric Card Cage
Step 3 To install the card, reverse the procedure in Step 2.
Step 4 Close the air filter door and tighten the captive screws.
26862
Switch fabric card
Air filter door