Bridge/Router Installation and Configuration Guide

Chapter 7 Maintaining the Router
Removing and Replacing an AC Power Supply
7-38
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
OL-11495-01
Step 5 Remove the 2500W PEM (Figure 7-22):
a. Loosen the captive screw to release the ejector handle.
b. Pivot the ejector handle down to eject the power supply from its backplane
connector.
c. Slide the power supply out of its bay while supporting it with your other hand.
Figure 7-22 Removing a 2500 W AC Power Supply
Step 6 Install the power supply:
• For 2000 W PEM—Go to Step 7.
• For 2500 W PEM—Go to Step 8.
Pw
r O
k
Fault
Te m
p
O
C
P
w
r O
k
Fault
Temp
O
C
129497
Pw
r O
k
Fault
Temp
O
C