Bridge/Router Installation and Configuration Guide

Chapter 7 Maintaining the Router
Removing and Installing the Front Covers and Bezel Extenders on Original Cisco 12000 Series Routers
7-4
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
OL-11495-01
Installing the Front Covers
Refer to Figure 7-1 and use the following procedure to install the front covers.
Step 1 Hold the upper blower module front cover by its outside edges and align the ball
studs with the ball stud clips on the front of the chassis.
Step 2 Push the front cover into the ball stud clips and the front cover is flush with the
front of the chassis.
Step 3 Repeat Step 1 and Step 2 for the remaining front covers.