Bridge/Router Installation and Configuration Guide

6-9
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
OL-11495-01
Chapter 6 Router Field Diagnostics
Using the diag Command
Diagnostic Commands for Cisco 12000 Series Rout Processors
The following diagnostic commands apply to GRP and PRP route processors.
diag slot-number [verbose] [wait] [full] [coe]
diag slot-number previous
diag slot-number halt
Diagnostic Commands for Cisco 12000 Series Switch Fabric
Cards and Clock Scheduler Cards
The following diagnostic command applies to SFC and CSC fabric cards.
diag slot-number [verbose]
Diagnostic Command Reference Table
Table 6-1 lists the diag command keywords, options, variables, and their
descriptions.
Ta b l e 6-1 diag Command Reference
Command Description
slot-number Specifies the slot number of the card you want to test.
source Specifies the source path of the line card diagnostic image.
The source keyword must be followed by either the tftp or
flash keyword.
tftp Specifies that a TFTP server is the source of the diagnostic
image. The tftp keyword must be followed by the
source-path variable. To manipulate the download time for
slow TFTP connections, see the dl-timeout-plus option.
flash Specifies that a flash memory card is the source of the
diagnostic image. The flash keyword must be followed by
the source-path variable.