Switch User Manual
Table Of Contents
- Regulatory Compliance and Safety Information for the Catalyst Express 520 Switches
- Translated Safety Warnings
- Statement 17B-Overtemperature Warning
- Statement 43-Jewelry Removal Warning
- Statement 48-Stacking the Chassis Warning
- Statement 100C-Attaching the Cisco RPS (model PWR675-AC-RPS-N1)
- Statement 171-Ethernet Cable Shielding in Offices
- Statement 265-Redundant Power Supply Connection Warning
- Statement 266-Switch Installation Warning
- Statement 371-Power Cable and AC Adapter
- Statement 1001-Work During Lightning Activity
- Statement 1004-Installation Instructions
- Statement 1006-Chassis Warning for Rack-Mounting and Servicing
- Statement 1008-Class 1 Laser Product
- Statement 1017-Restricted Area
- Statement 1019-Main Disconnecting Device
- Statement 1024-Ground Conductor
- Statement 1028-More Than One Power Supply
- Statement 1030-Equipment Installation
- Statement 1040-Product Disposal
- Statement 1044-Port Connections
- Statement 1046-Installing or Replacing the Unit
- Statement 1071-Warning Definition
- Statement 1072-Shock Hazard from Interconnections
- Statement 1073-No User-Serviceable Parts
- Statement 1074-Comply with Local and National Electrical Codes
- Statement 1079-Hot Surface
- European Directives
- Regulatory Standards Compliance
- EMC Environmental Conditions for Products Installed in the European Union
- EMC Class A Notices and Warnings
- Switch Documentation Set
- Obtaining Documentation, Obtaining Support, and Security Guidelines
- Translated Safety Warnings
11
Regulatory Compliance and Safety Information for the Catalyst Express 520 Switches
OL-13012-02
Regulatory Compliance and Safety Information for the Catalyst Express 520 Switches
Translated Safety Warnings
Statement 265—Redundant Power Supply Connection Warning
Warning
If a redundant power system (RPS) is not connected to the switch, install an
RPS connector cover on the back of the switch.
Statement 265
Waarschuwing
Als er geen redundant voedingssysteem (RPS) aan de schakelaar is
gekoppeld, dient u een RPS-connectorkapje op de achterkant van de
schakelaar te installeren.
Varoitus
Jos korvautuvaa tehojärjestelmää (redundant power system, RPS) ei ole
liitetty kytkimeen, kiinnitä RPS-liittimen suojus kytkimen takapuolelle.
Attention
Si un système d’alimentation électrique redondant (RPS) n’est pas connecté
au commutateur, installez un cache de connecteur RPS à l’arrière du
commutateur.
Warnung
Wenn keine redundante Stromversorgung (RSV) an den Schalter
angeschlossen ist, eine RSV-Steckerabdeckung an der Rückseite des
Schalters anbringen.
Avvertenza
Se un sistema RPS (Redundant Power System ) di alimentazione ridondante
non è collegato al dispositivo switch, installare un copri-connettore RPS sul
retro del switch.