Network Card User Manual

Catalyst 6500 Series DFC3A, DFC3B, and DFC3BXL Installation Note

78-15893-06

Upgrading the DFC3BXL Daughter Card Memory

Figure 12 Handling a SODIMM

Step 5 Immediately place the old SODIMM in an antistatic bag to protect it from ESD damage.

Installing the SODIMM

Caution SODIMMs are sensitive components that are susceptible to ESD damage. To prevent ESD damage,

handle SODIMMs by the edges only; avoid touching the memory modules, pins, or traces (the metal

fingers along the connector edge of the SODIMM). (See Figure 12.)

To install the 1-GB SODIMM, follow these steps:

Step 1 Remove a new SODIMM from the antistatic shipping bag.

Step 2 Hold the SODIMM with the component side up and with the connector edge (the metal fingers) away

from you.

Step 3 Hold the sides of the SODIMM between your thumbs and forefingers. (See Figure 12.)

Step 4 Tilt the SODIMM to approximately the same angle as the socket, and insert the connector edge into the

socket.

Caution When inserting SODIMMs, use firm but not excessive pressure. If you damage a socket, you will have

to return the DFC to the factory for repair.

Step 5 Press the SODIMM down until it is secured by the spring clips. (See Figure 13.)

51544