Bridge/Router Installation Guide

4-12
Cisco CRS-1 Carrier Routing System 4-Slot Line Card Chassis Installation Guide
OL-10971-07
Chapter 4 Installing and Removing SFCs, RPs, MSCs, PLIMs, and Associated Components
How to Remove or Install a Card Slide-Assistance Arm (Handle)
Figure 4-8 Modular Services Card (CRS-MSC) with Slide-Assistance Arm Attached
Removing a Card Slide-Assistance Arm
This section describes how to remove a slide-assistance arm (handle) from an MSC, PLIM, or RP card.
For details about installing or removing the cards themselves, see the
“How to Install or Remove a
Modular Services Card” section on page 4-33, the “How to Install or Remove a PCMCIA Card” section
on page 4-50, and the “How to Install or Remove a Physical Layer Interface Module” section on
page 4-41.
111847