Bridge/Router Installation Guide

CHAPTER

4-1

Cisco CRS-1 Carrier Routing System 4-Slot Line Card Chassis Installation Guide

OL-10971-07

Installing and Removing SFCs, RPs, MSCs,

PLIMs, and Associated Components

This chapter provides instructions on how to install and remove the Cisco CRS-1 Carrier Routing System

4-Slot Line Card Chassis switch fabric cards (SFCs), route processors (RPs), modular services

cards

(MSCs), physical layer interface modules (PLIMs), and the associated components.

This chapter presents the following topics:

• About Installing and Removing Cards and Associated Components

• How to Remove or Install an Impedance Carrier

• How to Remove or Install a Card Slide-Assistance Arm (Handle)

• How to Install or Remove a Pillow Block

• How to Install or Remove a Switch Fabric Card

• How to Install or Remove a Route Processor Card

• How to Install or Remove a Modular Services Card

• How to Install or Remove a Physical Layer Interface Module

• How to Install or Remove a PCMCIA Card

• How to Install or Remove a Small Form-Factor Pluggable (SFP) Module

About Installing and Removing Cards and Associated

Components

This section contains some general information about installing and removing cards, PLIMs, and the

associated components.

• Guidelines for Card Installation and Removal

• PCMCIA Cards

• Small Form-Factor Pluggable (SFP) Modules

• Cable Management Brackets