Bridge/Router Installation Guide

Contents
v
Cisco CRS-1 Carrier Routing System 4-Slot Line Card Chassis Installation Guide
OL-10971-07
Installing a Pillow Block 4-14
Removing a Pillow Block 4-16
How to Install or Remove a Switch Fabric Card 4-18
Switch Fabric Card Location and Slot Numbers 4-18
Installing a Switch Fabric Card 4-18
Removing a Switch Fabric Card 4-22
Verifying the Installation of a Switch Fabric Card 4-24
How to Install or Remove a Route Processor Card 4-25
Location and Slot Numbers for the RPs, MSCs, and PLIMs 4-25
Installing an RP Card 4-26
Removing an RP Card 4-29
Verifying the Installation of an RP Card 4-31
How to Install or Remove a Modular Services Card 4-33
Installing an MSC 4-33
Removing an MSC 4-37
Verifying the Installation of an MSC 4-40
How to Install or Remove a Physical Layer Interface Module 4-41
Installing a PLIM 4-41
Removing a PLIM 4-46
Verifying the Installation of a PLIM 4-49
How to Install or Remove a PCMCIA Card 4-50
Installing a PCMCIA Card 4-50
Removing an RP PCMCIA Card 4-51
How to Install or Remove a Small Form-Factor Pluggable (SFP) Module 4-52
Installing a Bale-Clasp SFP Module 4-53
Removing a Bale-Clasp SFP Module 4-54
Installing and Removing the Doors and Grille 5-1
Overview of the Exterior Components 5-1
Installing the Inlet Grille 5-2
Removing the Inlet Grille 5-3
Installing the Doors 5-4
Opening the Doors 5-7
Removing the Doors 5-8
APPENDIX A Cisco CRS-1 4-Slot Line Card Chassis System Specifications A-1
Compliance and Safety Reference A-1
Cisco CRS-1 4-Slot Line Card Chassis Specifications A-1