Bridge/Router Installation Guide

Index
IN-6
Cisco CRS-1 Carrier Routing System 4-Slot Line Card Chassis Installation Guide
OL-10971-07
PLIM 4-41, 4-46
power supply 2-28
power tray air filter 3-12
RP card 4-25, 4-29
SFP modules 4-52
switch fabric card 4-22
wiring block covers 2-19
requirements
airflow exhaust 1-8, 3-3
DC input power connections 2-6
routing system
air filter 3-2
airflow and exhaust 3-3
chassis midplane 1-3
components 1-2
front and back 1-4
switch fabric cards 1-4
RP card
(figure) 4-27, 4-30
front panel (figure) 4-32
installation guidelines 4-26
installing 4-25, 4-26
LEDs 4-32
monitoring start-up process 4-26
PCMCIA slot door (figure) 4-50
removing 4-25, 4-29
verifying 4-31
S
safety guidelines 1-8
SFP
bale-clasp (figure) 4-53, 4-54
installing bale-clasp (figure) 4-54
removing bale-clasp (figure) 4-56
SFP modules
information about 4-4
installing 4-52
removing 4-52
shock and vibration specifications, system A-3
slide-assistance arm 4-11
slide-assistance arm (figure) 4-12
slot numbers 1-5
front (figure) 1-5, 4-25
MSC side 1-6
rear (figure) 1-6, 4-18
specifications
acoustic noise A-3
altitude A-3
chassis A-1
humidity A-3
shock and vibration A-3
temperature A-3
supplemental grounding guidelines 2-2
switch fabric card
(figure) 4-19, 4-22
front view (figure) 4-24
installing 4-18
installing (figure) 4-20
LEDs 4-24
removing 4-22
removing (figure) 4-23
troubleshooting 4-24
verifying installation 4-24
switch fabric cards 1-4
T
Telcordia GR-1089 NEBS standard 4-29
temperature, system specifications A-3
thermal alarms 4-4
torque ranges, DC power lug A-2
torque values
DC PIM wiring block 2-8
ground wire 2-8
power cables 2-8