Bridge/Router Installation Guide

Index
IN-5
Cisco CRS-1 Carrier Routing System 4-Slot Line Card Chassis Installation Guide
OL-10971-07
installing (figure) 4-36
LEDs 4-40
and PLIMs 1-3
removing 4-1, 4-37
removing (figure) 4-39
troubleshooting 4-41
verifying installation 4-40
MSC-side slot numbers 1-6
N
NEBS
bonding (figure) 2-3
grounding (figure) 2-3
Telcordia GR-1089 standard 4-29
O
online insertion and removal (OIR) 4-2
overview of line card chassis 1-1
P
PCMCIA card
installing 4-50
overview 4-4, 4-50
removing 4-50, 4-51
RP card slot door (figure) 4-50
pillow block
installing 4-14
removing 4-16
PIM. See DC power input module
PLIM
(figure) 4-42, 4-47
front panel (figure) 4-49
installing 4-41
installing (figure) 4-44
and MSC 1-3
removing 4-41, 4-46
removing (figure) 4-48
troubleshooting 4-50
verifying 4-49
polarity, verifying (DC power) 2-7, 2-15
power components
installing 2-1
power supply
figure 2-26
installation 2-25
removing 2-28
weight of 2-27
power system
DC input power connections 2-6
line card chassis 1-8
powering chassis up or down 2-4
power supply (figure) 2-28
power tray air filter (figure) 3-11, 3-12
recommendations 2-1
preventing electrostatic discharge 1-9
R
removing
AC power shelf 2-23
air circulation components 3-3
air filter 3-9
bale-clasp SFP 4-54
DC power input cables 2-20
DC power input module (figure) 2-21
DC power input shelf 2-20, 2-21
DC power shelf 2-18
doors 5-8
fan try 3-5, 3-7
grille 5-3
MSC 4-37
MSCs, PLIMs, components 4-1
PCMCIA card 4-50, 4-51
pillow block 4-16