Bridge/Router Installation Guide

Index
IN-3
Cisco CRS-1 Carrier Routing System 4-Slot Line Card Chassis Installation Guide
OL-10971-07
F
fabric card
(figure) 4-19, 4-22
installing 4-18
removing 4-22
fan tray
figure 3-4, 3-6
hot swapping caution 3-6
installation steps 3-5
installing 3-4
removing 3-5, 3-7
Figures
AC power enable switches 2-5
AC power shelf 2-22
air filter (chassis) 2-17, 3-8, 3-9
air filter (power tray) 3-11, 3-12
airflow 1-8, 3-2, 3-3
bale-clasp SFP 4-53, 4-54
cable management bracket 1-7, 4-5
card handle 4-12
DC power cable lug 2-7
DC power input module (PIM) 2-13
DC power input shelf 2-14
DC Power Shelf 2-6
DC power shelf coupling screw 2-15
DC power shelf enable switches 2-19
DC power shelf wiring 2-16
DC power supplies 2-17
ejector levers and captive screws 4-2
fan tray 3-4, 3-6
front view of line card chassis 1-2
installing a pillow block 4-16
installing bale-claps SFP 4-54
installing MSC 4-36
installing PLIM 4-44
installing switch fabric card 4-20
MSC 4-34, 4-36
MSC impedance carrier 4-9
NEBS bonding and grounding 2-3
operating ejector levers 4-3
PLIM 4-42, 4-47
PLIM front panel 4-49
PLIM impedance carrier 4-8
Power Input Module (DC power) 2-8
power supply 2-26
power supply door grile in open position 2-27
power supply door grille and latch 2-29
power supply on CRS-1 4-slot router 2-28
rear view of line card chassis 1-3
removing a pillow block 4-17
removing bale-clasp SFP 4-56
removing MSC 4-39
removing PLIM 4-48
removing switch fabric card 4-23
removing the DC power input module (PIM) 2-21
removing the DC power input shelf 2-21
removing wiring block covers and DC power input
cables
2-20
RP card 4-27, 4-30
RP card front panel 4-32
RP card PCMCIA slot door 4-50
RP impedance carrier 4-7
slide-assistance arm 4-12
slot numbers (front) 1-5, 4-25
slot numbers (rear) 1-6, 4-18
switch fabric card 4-19, 4-22
switch fabric card (front view) 4-24
switch fabric slot impedance carrier 4-6
filter, air 1-7, 3-2
G
grille
installing 5-2
removing 5-3