Bridge/Router Installation Guide

4-54
Cisco CRS-1 Carrier Routing System 4-Slot Line Card Chassis Installation Guide
OL-10971-07
Chapter 4 Installing and Removing SFCs, RPs, MSCs, PLIMs, and Associated Components
How to Install or Remove a Small Form-Factor Pluggable (SFP) Module
Figure 4-33 Installing a Bale-Clasp SFP Module into a Port
Removing a Bale-Clasp SFP Module
This section describes how to remove a bale-clasp SFP module. The module has a clasp used to install
and remove the module (see
Figure 4-34).
Figure 4-34 Bale-Clasp SFP Module
Prerequisites
Before removing a module, disconnect any connected interface cables.
116294
63067